From Wanos Wiki
(→Deployment Design) |
(→Deployment Design) |
||
| Line 55: | Line 55: | ||
* [[Firewall]] | * [[Firewall]] | ||
* [[High Availability]] | * [[High Availability]] | ||
| − | * [ | + | * [http://wanos.co/docs/docs/wanos-admin-guide/configuration/multisite/ MultiSite] |
* [http://wanos.co/docs/docs/wanos-admin-guide/deployment/router-mode/ Router Mode – Out of Path] | * [http://wanos.co/docs/docs/wanos-admin-guide/deployment/router-mode/ Router Mode – Out of Path] | ||
* [http://wanos.co/docs/docs/wanos-admin-guide/deployment/tunnel-mode/ Tunnel Mode – Out of Path] | * [http://wanos.co/docs/docs/wanos-admin-guide/deployment/tunnel-mode/ Tunnel Mode – Out of Path] | ||
Revision as of 15:57, 21 September 2016
Contents
Introduction
Minimum Hardware Requirements
Guides
General
VMware ESXi
Hyper-V
KVM
XenServer
Bare Metal
Configuration
Settings
Features
Deployment Design
- Firewall
- High Availability
- MultiSite
- Router Mode – Out of Path
- Tunnel Mode – Out of Path
- Bridge Mode - In Path
Troubleshooting
- Change wan0 and lan0 pair for NIC Bypass
- Insufficient Disk Space
- Network_debug
- Optimization
- Out of band management
- Peer detected on lan0
- Peer Down
- Remove RDP from the default interactive bypass group
- Slow Performance
- WAN Optimization over IPsec
- Boot Wanos in 32-bit mode
FAQ
- Autostart Wanos VM in Esxi
- Backup and Restore Configuration
- Bi-directional Optimization
- Change DataStore Location
- Change IP Address
- Clone a live Wanos machine running from a Flash Drive to a Physical Disk
- Configure NTP
- Configure Serial Console
- How to shutdown a Wanos Appliance
- Hyper-V is not detecting network cards
- Is VMware ESXi Free
- No Optimization of Encrypted Protocols
- Only One Appliance
- Traffic is Not Flowing through the Bridge
- What happens when Datastore is full?