Just to add:
1) In lab setup using v.3 in bridge mode then the only absolute requirement is IP address and wan0 cables connected to the wan network. No other config is absolutely required to get optimization to work.
2) v.3 yes. The default Express license does not expire.
3) If there is an IPsec tunnel between the server and workstation then no optimization would not work. Traffic between server and workstation should be plain TCP type of traffic. IPsec between router-A and router-B is ok
I get it,
I will be testing in my real scenario and I will be reporting the results
Thank you very much !!
Today I hope to carry out the tests, however I have some doubts regarding your aggregations:
1- "In lab setup using v.3 in bridge mode then the only absolute requirement is IP address and wan0 cables connected to the network .No other config is absolutely required to get optimization to work."
My scenario is the following:
-Site Server:
The router has a public ip
-Site Workstation
The router has a private ip (NAT 3).
Wanos will work under this scenario?
2- v.3 yes. The default Express license does not expire.
This is perfect !!!
3- "If there is an IPsec tunnel between the
server [/ b] and workstation [/ b] then no [/ b] optimization would not work. TCP type of traffic. IPsec between router-A and router-B is ok "
Continuing with my Scenario:
-Site Server:
Here I have a Firewwall connected from under the router
-Site WorkStation:
Here I have a Firewall connected from under the Router
Both Firewall establish an IPSec tunnel, in certain occasions I use SSL.
- Under this scenario, should I connect WANOS on top of my Firewall? or low
- In this way will WANOS work?
I wait for your help.
Thank you very much !!!