Hello,
We are trying WanOS v3.2.3 VM on 2 sites (HQ and Branch) in bridge mode, following the tutorial here:
http://wanos.co/docs/docs/wanos-admin-guide/installation/hyper-v/The VMs are using 2gb of ram and 4cores each
We use TMG as UTM, witch closes an ipsec tunnel from HQ to Branch
Normally, is is like this:
Branch and HQ both uses an 20/20mbps dedicated link, HQ is 172.0.10.0/24 and branch 172.0.20.0/24
HQ-LAN - HQ-TMG - Internet - Branch-TMG - Branch-LANWhat we are trying to achieve is this:
HQ-LAN - HQ-WAN_OS - HQ-TMG - Internet - Branch-TMG - Branch-WAN_OS - Branch-LAN
TMG has a WAN and LAN nic, the WAN nic is attached to a port connected directly to the internet router, the LAN to the local LAN
WanOS virtual WAN port is attached to the virtual LAN interface of the TMG, its LAN port is configured as internal-onlyb on Hyper-V
We can see traffic passing on WanOS dashboard on both ends, but no optimized traffic rx/tx, only pass-through
Peer status always list as "Idle", regardless of how we configure multisite
We tried changing encapsulation from ipcomp to udp on both ends, no luck
We even tried to trial keys on both ends to see if this was a problem, no luck
In both sites, the logs don't show the "peer detected on lan0" messages
Diagnostics screens shows all "OK" except password changed, which we don't believe may be the source of the problem
Did we miss a step in the configuration?
How can we diagnose the problem to make sure TMG is not the issue?
Thanks!