WanOS bridge on oVirt (KVM) pass only icmp

[robert]

WanOS v4.2.1 64-bit Plus 1000/1000 installed on oVirt (KVM) in bridge mode pass only icmp traffic, any other protocols (udp, tcp) not passing. On oVirt VM properties macspoof = true. Tried to create bypass policy for udp, tcp, udp 53 - no luck. Web cache and TCP-X are disabled. Nothing interesting in logs. From test VM connected to the same vlan as lan0 WanOS interface I'm able to ping and traceroute any other hosts outside of wan0 interface.
network setup: client VM (eth0 192.168.0.10) - vlan2 - lan0 WanOS VM (wan0 192.168.0.254) - vlan1 - 192.168.0.1 gateway router.
Any suggestions?

[ahenning]

Hi Robert,

If it was a case where the ICMP, UDP and HTTPS passed, but other TCP e.g. HTTP and FTP not, then traffic policies etc could be looked at. I think the problem is lower down on the KVM virtual Interface/VLAN config level.

Can you dedicate a separate physical interface for lan0 and wan0? If not, perhaps test with tunnel mode.

Feel free to send the support query to support at wanos