Author Topic: multiple networks via same tunnel (tunnel mode)  (Read 6178 times)

wgoffman

  • Member
  • ***
  • Posts: 9
    • View Profile
multiple networks via same tunnel (tunnel mode)
« on: February 09, 2018, 10:09:31 AM »
hi

i set tunnel from location_1 (172.20.33/24) to central_office (172.20/16) (tunnel mode on 4.2.1).
works fine.

i've additional networks @central_office (10/8 and 192.168/16) which i'd like to route from location_1 via tunnel.

obviously, i could route 0/0 via tunnel and add several 'no tunnel' for non-rfc1918 addresses. but it seems to me that this is not a good deal.

i tried to add second tunnel for 10/8 network with the same settings - but it didn't start ;-)

could somebody please point me how to route several networks via tunnel?

thx

JohnNicholas

  • Team Wanos
  • Contributor
  • Full Member
  • ****
  • Posts: 26
    • View Profile
Re: multiple networks via same tunnel (tunnel mode)
« Reply #1 on: February 09, 2018, 10:46:58 AM »
Hello,

To route multiple subnets over the same tunnel, use the same tunnel ID for each subnet :)

Unless I misunderstood the question?
CCNA

wgoffman

  • Member
  • ***
  • Posts: 9
    • View Profile
Re: multiple networks via same tunnel (tunnel mode)
« Reply #2 on: February 09, 2018, 01:31:24 PM »
thx, it's exactly i was looking for