Packet loss recovery config

[lexyus]

done. it works. Thanks a lot ahenning! you're the man!

[lexyus]

dear ahenning, my PLR status was going off after about 10 minutes online, is this what you mean by "throughput on Wan Tx is over 6 mbps". I tried to reset the service, going online and about next 10 minutes is PLR is off again.

thanks for reply

[ahenning]

Hi Lexyus,

It could be depending on the throughput.

Also take note of rules 96 and 97 that bypass traffic. If any devices on the .7 and .6 range is between the two wanop devices (e.g. firewall/routers), they need to be bypassed.  These rules need to be very specific at the moment (Auto config planned).

[lexyus]

well.. between two wanop devices is just routers.
wanos (192.168.6.41)  <---> routers   <-----> WAN <----->     routers <---> wanos (192.168.7.41)

I tried to add bypass policy : (0.0.0.0/0  to 192.168.6.1/24 )  and (0.0.0.0/0  to 192.168.7.1/24) but peer status goes down. Must be some mistakes i made with the policy. hehe..  by the way, do my posts needs to be move to another specific thread?  for more convenient others to read.

[ahenning]

I'll move them to 'troubleshooting'

Please send me the registration tokens so we can load trial keys to see if the express limit is the cause

[ahenning]

Thanks, emailed the keys.

[lexyus]

Thanks you very much ahenning,

will update you tomorrow

[lexyus]

Hi ahenning,

sorry for late reply. I have tried to attach the keys and both of wanos is now licensed plus. But the PLR still went off status. If I reset the services, PLR went ON, but suddenly went OFF again. Do i miss something?