Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - saurabh

Pages: [1]
1
May be I am not able to explain.. Let me elaborate the scenario.
I have a LAB setup as shown below:
LAN -> WANOS (HQ) -> Router <-> Router ->WANOS (Branch) -> LAN

I ran 4 test cases.
1. FTP traffic, LAN to LAN, WANOS at both ends, Throughput 10 Mbps
2. FTP traffic, LAN to LAN, remove WANOS from Branch, Throughput 1Mbps
3. FTP traffic, LAN to LAN, remove WANOS from HQ also, Throughput 100 Mbps
4. HTTP traffic, LAN to LAN, WANOS at both ends, Throughput 1 Mbps

As per my understanding, WANOS v3 is of express license, so throughput will decrease to 1/10 i.e 10 Mbps, which is working fine. But as soon as I remove WANOS device from Branch, throughput drops to 1 Mbps. It should not drop.

Similarly, with HTTP traffic, throughput in first run is 10 Mbps, but if we download same file again, it drops to 1 Mbps.

2
Hi,

Throughput end to end without WANOS device in any end is 10 MB/s.
If WANOS device is deployed at both ends, similar drop in throughput is observed with HTTP traffic.
Is there free/evaluation license for v.4?

3
Hi,

I am running below scenario in LAB in bridged mode:

LAN -> WANOS (HQ) -> Router <-> Router ->WANOS (Branch) -> LAN

Note:- There is IPSec tunnel between edge routers.

In this deployment scenario I am getting 1 MB/s throughput (due to express license), but when I removed WANOS from Branch Office and configure WANOS-HQ for Pass through traffic, FTP throughput drops to 118 KB/s. Is there any configuration which I should take care?

Thanks

Pages: [1]