Messages

1

Hardware / Re: Interfaces LAN1 et LAN2 bypassed after boot on Wanos 450

« on: May 12, 2017, 06:08:21 PM »

Hi again,

The problem was solved last monday with ahenning's help (thank you again:)).

For info, it was a driver problem. I replaced my driver with another one that I got from ahenning and then, the appliance started working as expected.

Regards.

2

Hardware / Interfaces LAN1 et LAN2 bypassed after boot on Wanos 450

« on: May 06, 2017, 04:10:12 PM »

Hi everybody,

I'm setting up now a Wanos 450 appliance and I've noticed the following behaviour:

After boot, interfaces LAN1 and LAN2 are bypassed (so shutted) and to bring them up, I have to use the appliance's buttons to disable bypass.

Is it the normal behaviour of Wanos 450 ? That is not the case for Wanos 300.

Thank you very much.

Regards.

3

Configuration / Re: SNMP configuration

« on: May 04, 2017, 05:29:33 AM »

Hi,

Thank you very much!

Regards.

4

Configuration / SNMP configuration

« on: May 03, 2017, 09:03:30 PM »

Hi everybody,

Could someone explain how to configure SNMP on Wanos 3.2.3, please ?

I'm trying to monitor a Wanos 300 appliance with a Plus license but I've got no answer to my SNMP requests so I think that there is some configuration to adjust.

Thank you for your help.

Regards.

5

Configuration / Re: Force speed and duplex

« on: May 02, 2017, 02:26:13 PM »

Hi ahenning,

Thank you very much. That's exactly what I need.

In fact, for your information, I can't use autonegociation because my WAN interface is connected to a telecom operator device and I can't change its configuration.

Thank you again.

Regards.

6

Configuration / Force speed and duplex

« on: May 02, 2017, 01:39:29 PM »

Hello everybody, this is my first post. First of all, thanks the Wanos team for the great job.

I'm setting up a Wanos 300 appliance and I need to force speed and duplex of my WAN interface to 100/full.
I have not found where I can do that at the web interface. Maybe it is not possible ?

Could anyone explain me which is the preferred way to modify speed and duplex settings on a Wanos appliance ?
The software version is 3.2.3 Prod.

Thank you very much in advance.

Regards.