Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - sacha.yunusic

Pages: [1]
1
Configuration / Re: QoS/Shapping with one box
« on: April 19, 2016, 01:56:22 PM »
I upgrade it to 3.0.3 and everything worked fine.
I tried one rule with low priority, another with shaping (and seems to work), and another with drop and also seems to work, but my question is: Where can I see the dropping statistics? In Network -- QoS Classes doesn't appear anything about the dropping.
PS: After doing this tests I still see the Peer Status as "down", even I see traffic in the QoS Classes section in the different classes I created (any different than 0 and 17).

2
Configuration / Re: QoS/Shapping with one box
« on: April 18, 2016, 02:58:06 PM »
Thanks for the answer.
I guessed that only works Tx traffic, so I try to switch interfaces. Even it says they were switched, nothing happened (I can tell because the MAC still in the same place), and in logs this is what I see: "Error : Configured WAN0 Interface not found (00:50:56:95:76:c2".
Here is the whole log: https://paste.fedoraproject.org/357023/
Any thoughts?

3
Configuration / QoS/Shapping with one box
« on: April 18, 2016, 02:32:54 PM »
Hi,
I'm testing a new WanOS virtual box (only one), and I want to do shapping on my traffic. This is my lab scenario:
Virtual_PC --- WANOS --- LAN ---- Internet
If I drop traffic, works fine, but if I try to do shapping (on Rxtraffic), nothing happened.
My rules was: source 0.0.0.0/0, dst 0.0.0.0/0, tcp-21, shape 10kbps
Is there any way to make this work?

Pages: [1]