Show Posts
1
Hardware / Silicom Dual Port Gig Ethernet Adapter PXG2BPIG-JP
« on: April 06, 2015, 07:50:16 PM »
I am trying to get WANOS up and running on a Juniper WXC 590. So far, after some fiddling, I am able to get it to boot and initialize the 'Management' interface on the Juniper. The primary card appears to be stuck in bypass mode. It is represented by lan0 in the attached images. Wan0 is the 'Management' interface on the front of the appliance.
The main NIC is a Silicom Dual Port Gig Ethernet Adapter PXG2BPIG-JP and as you can see in the pics, there appears to be a spot on the board where a 'Bypass Mode' switch could have been soldered. Is this NIC fully supported by WANOS? Or would I need to figure out a way to bypass it or replace it with one that is?
Thanks!
The main NIC is a Silicom Dual Port Gig Ethernet Adapter PXG2BPIG-JP and as you can see in the pics, there appears to be a spot on the board where a 'Bypass Mode' switch could have been soldered. Is this NIC fully supported by WANOS? Or would I need to figure out a way to bypass it or replace it with one that is?
Thanks!