Topics

1

General Discussion / Update Production Wanos Appliance from 2.0.1 to 2.04

« on: March 17, 2015, 12:55:47 PM »

Hi,

i've read your post for the new Version 2.0.4 and did a update in my lab.

I have a customer with a wanos appliance version 2.0.1 at the main office and one wanos appliance at the site office. My Main Office has a 10Mbit/s Up- and Download. The Remote Site has 5Mbit/s Download and about 0.75Mbit/s Upload. I am just optimizing traffic between this sites. So the new Up- and Download Restriction of Version 2.0.4 should not be a problem.

My Question:
What is the Best Practice to Update this to Version 2.0.4?

Thanks.
Kind Regards
Marco

2

General Discussion / Configuraton backup

« on: March 17, 2015, 12:49:13 PM »

Hi,

how i am able to backup my configuration in case of a desaster recovery situation?
In case my Hardware Wanos Appliance Harddrive crashes, i whould like to be able to change the faulty drive, install a fresh installation of wanos and recover my previous settings.

How i am able to do this?

Thanks.
Kind Regards
Marco

3

Deployment / VMware Deployment Question

« on: January 14, 2015, 09:46:25 AM »

Hi,

i have a Deploment Question for wanos.
I have multible VLANs (ID: 1-10) which are routed by a Layer 3 Core Switch. Additionally there is a "Transfer"-VLAN (ID 11) where my Core Switch and my Firewall are untagged Members. The Default Gateway of my Core-Switch is the Firewall.

Now i want to deploy an wanos VM.
I dont want to change any Routing, IPs or Default Gateways.
How i am able to deploy wanos? I think i should work with two different VLANs between my Core-Switch and my Firewall to place the wanos between them. Right?

Thanks!
Marco

4

Deployment / Deploqment Question over Cisco VPN Tunnel

« on: December 11, 2014, 02:13:08 PM »

Hello,

i have a deployment question.
There are two Sites (A and B). The Sites are connected over a VPN Tunnel (Cisco). The Headquarter is on Site A. Remote Office on Site B.

If my understanding is correct, the Deployment should look like this:
Site A - L3 Routing Switch - Wanos Core - Cisco FW ===L3 VPN-TUNNEL=== Cisco FW - Wanos Edge - L3 Routing Switch - Site B

My Main Question is how the tho Wanos Appliances can see each other? I installed a ESXi Lab Environment like described on your Page. Because the WAN Interface is on the same L2 Netzwork they connect each other automatically. But there is no way i found to give my Wanos Core the information which IP my Wanos Edge has (and vice versa). Because i have a Layer 3 Tunnel i am a little confused now.

Maybe someone has a simple answer to this.
Thanks a lot.

Best Regards
Marco