Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - whiskeyjack

Pages: [1]
1
Deployment / Re: How to set edge and core?
« on: October 28, 2014, 06:26:09 AM »
Hi,

Not all the traffic from both sites is going over the VPN, its a test VPN for Wanos. I have upgraded both sides to 1.4.1 and we are still not seeing the sites "up" in the peer status tab.

We have tried copying some files across and have not seen much optimization - the debug logs show them going active and idle but there is no timestamp to see when this happens.

I am sure this should work as a test scenario - or will it perform better if the devices see all the traffic?

We are just verifying if the palo alto does allow the proto 108 and TCP Option 76 through.


2
Deployment / Re: How to set edge and core?
« on: October 24, 2014, 09:34:04 AM »
Hi Antonie,

Do I need to enable multisite in this scenario?

I see the peers connect and time out periodically and we will do some proper testing with traffic over the VPN to see if they peer properly.


3
Deployment / Re: How to set edge and core?
« on: October 21, 2014, 06:10:16 PM »
Hi Antonie,

The jumper is set,  ;) I just noticed the time on my box is severely skewed (set to Jan 2003!) which is probably also contributing to things not behaving correctly. I am going to rebuild it and try again - I have disabled UDPEncap and will try with default settings in the morning.

I notice verbose debug options in /etc/wanos/wanos.conf is reset after a reboot or service reset - is this normal?

4
Deployment / How to set edge and core?
« on: October 21, 2014, 01:13:44 PM »
Hi all,

We have a two sites connected by an IPSec VPN tunnel. I have enabled the UDP encapsulation on both sides as I am not sure if the Palo Alto and pfSense allow IPComp so I am assuming they don't.

Both sides are running 1.3.4 and one site is a VM and they other an appliance.

I don't see how to set them as Core and Edge as it was before in the GUI. We don't see the peer in the "peer status" tab and no optimization although traffic is flowing between the devices.

How do we set this so they can "see" each other?

Kind regards,

Pages: [1]