Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - laoistom

Pages: [1]
Configuration / Re: Issues with initial Setup
« on: May 26, 2016, 07:45:19 PM »
@ahenning thank you for the clarification. So when the guide states not to connect LAN0 and WAN0 to the same network segment it means not to connect them to the same side of the network segment. Make sure that the only way for traffic to flow is through the WANOS appliance and not in a loop.

I'll give it another go then. Thanks for the quick reply.

Configuration / Issues with initial Setup
« on: May 26, 2016, 04:30:49 PM »
Hi Guys,

I'm brand new here and I'm having a little trouble wrapping my head around the setup for WANOS.

At the most basic level here is my issue :

I have an extremely basic network (

I have 3 machines on this network and the router (pfsense) is configured on

Now my understanding of how WANOS works is it is inserted into the network between my switch and the PFSense router in bridge mode so it is able to see all traffic destined to leave the network.

In all the documentation it is explicitly stated that the LAN and WAN interfaces on WANOS are NOT to be connected to the same LAN segment. Considering this how then am I supposed to connect the WANOS in my network. In order for all of my devices to be able to reach the gateway the WANOS appliance will have to pass the traffic through essentially putting both interfaces on the same network Segment.

If anyone has a few pointers for me on this it would be greatly appreciated.


Pages: [1]