Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - Fabio

Pages: [1]
Deployment / Re: New deployment - No Optimization - Peer down
« on: April 29, 2020, 10:26:15 PM »
Thank you all for your support. 

Deployment / Re: New deployment - No Optimization - Peer down
« on: April 27, 2020, 08:48:12 PM »
Thanks guys for your support and fast reply.
I apologise I haven't replied any sooner, I had an online examination today, so I haven't checked the forum since I first post the question.
I have one more problem now. Before you sent me the second licence, I was trying to add a WAN emulator (WANem) between both devices to add some noise in the channel. So, I was trying to route the traffic via the WANem but the static routes that I set on the WanOS WUI, did not work. Then I went on the WanOS appliance command line and forced the static routes. Furthermore, when I restarted the WanOS machine, they would boot but would automatically switch it off after a few seconds.
So I deleted those machines and made a new fresh deployment. The Licence that you have sent to me cannot be applied to those new machines. I have tried even changing the MAC address of the machine and still it does not accept the licences.
Could you please help me with this licence issue?

Best regards,

Deployment / New deployment - No Optimization - Peer down
« on: April 26, 2020, 03:58:51 AM »
Hi all.
I have made my first deployment of WanOS. This is for a college assignment. I used the recommended configuration guide for VM environment (using bridge mode). It did work and from the client site, I can access the webserver on HQ site. However, I haven't seen any improvement, the graphs and metrics for optimisation doesn`t display anything. Moreover, the graphs for passthrough display the traffic flowing. Also, I noticed the peer tab does not show the devices have peered, but it can ping each other (and traffic flow between them). I just doesn't understand much, why the optimisation graphs does not show a thing.  Note all the machined are in the same hypervisor, what separates them are the vlan tags only. Is anyone can help? If I am not able to prove that the traffic has been optimised I won't be able to finish my assignment.
I could not find much information on the documentation, but I was trying to add an IP address on the LAN0 interface, as I could possible try different scenarios as well.

Pages: [1]