Wan Optimization Support
Technical => Deployment => : badassbob August 14, 2014, 04:15:21 PM
-
Hello, and a good day to you. I was wondering what you recommend for hardware specs for greater than 1Gigabit speeds.
We are currently using Ecessa PowerLinks 175ehq models between 3 sites, and very soon we are adding a 1 gig point to point circuit between our main datacenter (Core) & our DR/backup site (edge). Our current powerlink units can do multilink channel bonding that we send our vpn traffic over, but they cannot handle more the 175-200M of traffic. So we are looking for a solution between our core datacenter & out backup site (and maybe even our other edge office).
What do you recommend for hardware based on the speeds of each circuit at each location (speed listed as down/up)
Core - datacenter
1G/1G
100M/100M
100M/20M
10M/10M
Backup DR sire
1G/1G
100M/100M
100M/20M
10M/10M
Office (edge) 3
50M/50M
50M/5M
5M/5M
Ideally we would like to bond these link together at each site & pass our vpn traffic through the bonded channel(s)
Any thought on hardware specs we should use to provide combined speeds above would be greatly appreciated.
Thanks!
-
Hi Bob,
The Ecessa flagship capabilities seems to be in the link bonding and link fail-over technology. This is not something that Wanos is configured to do.
That said, to bond multiple links is relatively simple. Without investigating the PowerLink tech in too much detail I believe the secret sauce will be in the link selection / load balancing algorithms.