Wan Optimization Support

Technical => Hardware => Topic started by: antunafr on May 06, 2017, 04:10:12 PM

Title: Interfaces LAN1 et LAN2 bypassed after boot on Wanos 450
Post by: antunafr on May 06, 2017, 04:10:12 PM
Hi everybody,

I'm setting up now a Wanos 450 appliance and I've noticed the following behaviour:

After boot, interfaces LAN1 and LAN2 are bypassed (so shutted) and to bring them up, I have to use the appliance's buttons to disable bypass.

Is it the normal behaviour of Wanos 450 ? That is not the case for Wanos 300.

Thank you very much.

Regards.
Title: Re: Interfaces LAN1 et LAN2 bypassed after boot on Wanos 450
Post by: antunafr on May 12, 2017, 06:08:21 PM
Hi again,

The problem was solved last monday with ahenning's help (thank you again:)).

For info, it was a driver problem. I replaced my driver with another one that I got from ahenning and then, the appliance started working as expected.

Regards.



Title: Re: Interfaces LAN1 et LAN2 bypassed after boot on Wanos 450
Post by: Vincent on June 01, 2017, 01:10:42 PM
Hello
i have the same problem.
After shutdown the appliance the bypass is disabled.

Regards