I wrote the wanos boot image from wanos-1.4.1.img using Win32diskimager and everything seemed to go well, but when I boot from the SSD on the RS140 system things seem to initialize until I get the error:
[Firmware Warn]: GHES: Failed to read error status block address for hardware error source: 1
That error just repeats every minute or so, boot never completes and I cannot get into the system
Even got the same error when I used clonezilla to image a VM to SSD.
Any ideas? I would like to run wanos on dedicated hardware vs ESXi + VM. Thanks.
To clarify, the system is a new Lenovo RS140 with an E3-1245 processor with 128GB SSD. (AHCI Mode)