Hello,
i have a deployment question.
There are two Sites (A and B). The Sites are connected over a VPN Tunnel (Cisco). The Headquarter is on Site A. Remote Office on Site B.
If my understanding is correct, the Deployment should look like this:
Site A - L3 Routing Switch - Wanos Core - Cisco FW ===L3 VPN-TUNNEL=== Cisco FW - Wanos Edge - L3 Routing Switch - Site B
My Main Question is how the tho Wanos Appliances can see each other? I installed a ESXi Lab Environment like described on your Page. Because the WAN Interface is on the same L2 Netzwork they connect each other automatically. But there is no way i found to give my Wanos Core the information which IP my Wanos Edge has (and vice versa). Because i have a Layer 3 Tunnel i am a little confused now.
Maybe someone has a simple answer to this.
Thanks a lot.
Best Regards
Marco