1
Deployment / Re: How to set edge and core?
« on: October 28, 2014, 06:26:09 AM »
Hi,
Not all the traffic from both sites is going over the VPN, its a test VPN for Wanos. I have upgraded both sides to 1.4.1 and we are still not seeing the sites "up" in the peer status tab.
We have tried copying some files across and have not seen much optimization - the debug logs show them going active and idle but there is no timestamp to see when this happens.
I am sure this should work as a test scenario - or will it perform better if the devices see all the traffic?
We are just verifying if the palo alto does allow the proto 108 and TCP Option 76 through.
Not all the traffic from both sites is going over the VPN, its a test VPN for Wanos. I have upgraded both sides to 1.4.1 and we are still not seeing the sites "up" in the peer status tab.
We have tried copying some files across and have not seen much optimization - the debug logs show them going active and idle but there is no timestamp to see when this happens.
I am sure this should work as a test scenario - or will it perform better if the devices see all the traffic?
We are just verifying if the palo alto does allow the proto 108 and TCP Option 76 through.