1
Deployment / How to set edge and core?
« on: October 21, 2014, 01:13:44 PM »
Hi all,
We have a two sites connected by an IPSec VPN tunnel. I have enabled the UDP encapsulation on both sides as I am not sure if the Palo Alto and pfSense allow IPComp so I am assuming they don't.
Both sides are running 1.3.4 and one site is a VM and they other an appliance.
I don't see how to set them as Core and Edge as it was before in the GUI. We don't see the peer in the "peer status" tab and no optimization although traffic is flowing between the devices.
How do we set this so they can "see" each other?
Kind regards,
We have a two sites connected by an IPSec VPN tunnel. I have enabled the UDP encapsulation on both sides as I am not sure if the Palo Alto and pfSense allow IPComp so I am assuming they don't.
Both sides are running 1.3.4 and one site is a VM and they other an appliance.
I don't see how to set them as Core and Edge as it was before in the GUI. We don't see the peer in the "peer status" tab and no optimization although traffic is flowing between the devices.
How do we set this so they can "see" each other?
Kind regards,