Wan Optimization Support

Technical => Troubleshooting => : Anil Kumar H October 13, 2014, 06:29:55 AM

: How to bypass the policies which is already added
: Anil Kumar H October 13, 2014, 06:29:55 AM

Hi,

I see check box not working after adding policies without bypass, later if I want to select the rule to bypass, its not possible to "tick it". I have to delete the rule & re-add again to bypass & vice versa.

: Re: How to bypass the policies which is already added
: ahenning October 13, 2014, 08:32:33 PM

Yes, that's correct, remove then add. If you are looking for a feature not available, please use the feature request thread.

: Re: How to bypass the policies which is already added
: Anil Kumar H October 15, 2014, 09:34:22 AM

Same rule with bypass & without bypass, which one will take priority ?

10.9.64.0/24 10.9.17.0/24 without bypass
10.9.64.0/24 10.9.17.0/24 with bypass

: Re: How to bypass the policies which is already added
: ahenning October 15, 2014, 09:46:18 AM

The one with the lower number. Like a Cisco ACL i.e. Top down.