Technical > Deployment

Setup in Lab between branch Office and HQ through a VPN

<< < (2/4) > >>

ahenning:
Lastly tcpdump shows https traffic, so not expecting to see options there.

smadon:
hi,

I am getting more confused :-(
I took out the both router and plug both server on the same switch. (network map attached)
and I still don't see any optimize traffic.

I attached as well the TCP Dump for both server.

is the Option 76 still not going through the LAN ?

Thanks for your help.

ahenning:
Good idea to make a simple setup first.

There are no TCP option 76 tags in the TCPdump and therefore optimization is not going to work until that has been resolved:
1) Check that lan0 connects to the LAN side. In other words lan0 connects to the server on the HQ side. lan0 on the branch side connects to the workstation. Both wan0 connects to the network in between them, normally the routers/firewalls. Use the MAC address to determine that it is correct.
2) If running v.4.1.3, make sure the status says licensed and not "Unlicensed - Bypass". If bypass, send the tokens to support at wanos
3) Check the traffic policies to ensure that traffic is not bypassed with a bypass rule.

Think about it, after installing the images, all that is needed is to connect the wan0 interfaces together and start generating non-bypassed TCP traffic. If running >=4.1.3, then load a key as well.

smadon:
AHHHH !!
the second point is the issue.
I am still having "Unlicenced - Bypass", I will send another request fror the token to the support right now.
Do you know how long it will take then? I send 2 request (one for HQ and Branch Office) but still waiting the answer.

I will keep you inform if the licence solve my issue.

Regards

ahenning:
Usually within a couple hours. Please send an email to support at wanos from. Sometimes trial keys are registered from an email address, that does not exist

Edit: postmaster undeliverable to hes-co.ch

Navigation

[0] Message Index

[#] Next page

[*] Previous page