Technical > Hardware
Silicom Dual Port Gig Ethernet Adapter PXG2BPIG-JP
satburn:
Ok, let me give it a try! I'll report back and let you know if we can get this thing a going.
satburn:
--- Quote from: ahenning on April 08, 2015, 12:04:31 AM ---Download and extract the VHD version of v.2.0.5 (It uses the older kernel)
Convert the VHD to RAW disk image format. It should create a 64GB disk image.
--- End quote ---
I'm getting about an 8GB raw image file, is that correct? I'm using qemu-img for Windows to do it.
ahenning:
Not familiar with qemu-img, but I think it converted to a sparse raw image. Not sure if it will boot. Taking a look into it.
Edit: Writing the sparse raw disk created by qemu-img to HDD did not work.
satburn:
--- Quote from: ahenning on April 08, 2015, 09:01:34 PM ---Not familiar with qemu-img, but I think it converted to a sparse raw image. Not sure if it will boot. Taking a look into it.
Edit: Writing the sparse raw disk created by qemu-img to HDD did not work.
--- End quote ---
What do you recommend?
ahenning:
An image will be ready tomorrow pre-loaded with the silicom e1000bp driver, so the process will be as per normal: write to drive, boot, check interfaces.
It's worth a shot, if the card and bypass toggling works then we'll get a couple to experiment with in the lab and make it officially supported.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version