WanOS behind pfsense by UDPENCAP=Enable didn't work for me. Is it possible for you to create a similar setup at your side and verify?
To continue with my tests I switched to following setup;
ISP Cable connects to WanOS wan0
WanOS Lan0 connects to PFSense wan
PFSense lan connects to lan switch
Desktops connect to lan switch
So far peers are up and I see graph data under Wan Tx Reduction columns.
I am using this tool to generate traffic
http://www.roadkil.net/program.php/P5/CommTest for testing
Can you verify my traffic policies are correct? I just want optimization between 10.10.9.150 and 10.10.8.137.
The only thing with this setup is, assigning public ip to WanOS for management.
I tried Wanos Out of band management as mentioned at link
http://wanos.co/forum/index.php?topic=49.0 but it did not work.
Added third nic in WanOS appliance connecting to LAN. sudo vi /opt/bootlocal.sh to add
ifconfig eth2 192.168.210.99 netmask 255.255.255.0 broadcast 192.168.210.255 up
question - Do I still need to assign another ip e.g. 192.168.210.200 using wanos-cfg ?
Can you assist here?
SiteA :- Wan IP - 10.10.9.150/22 Lan network- 192.168.210.0/24 GW - 192.168.210.1
SiteB :- Wan IP - 10.10.8.137/22 Lan network- 192.168.220.0/24 GW - 192.168.220.1
I'll further continue to test vpn traffic between these two sites.
Thanks