1
Deployment / wanos + ESXi with pfSense NAT
« on: December 23, 2014, 04:05:18 PM »
I have a similar setup on pfsense (simulating two sites on one esxi host), but I guess it's not working because local status is READY but Peer Status is Down
Traffic policies are default.
I have verified port connections are correct by matching mac addresses
Promiscuous Mode enabled on ports Lan, Lan_010, Main, Main_010
The setup as shown in attachment is as follows;
Pfsense, WanOs, Win7 (default ports)
Pfsense_010, WanOS_010, Win7_010 (Vlan10)
vSwitch2 is acting as a bridge between Pfsense & WanOs
On Win7, there is a website hosted and it can be accessed locally i.e. http://localhost.
If the website is accessed from Win7_010 (pfsense has nat rule for publishing http), site won't load and
internet & access to pfsense web gui stops for couple of minutes from both desktops.
Please suggest.
Traffic policies are default.
I have verified port connections are correct by matching mac addresses
Promiscuous Mode enabled on ports Lan, Lan_010, Main, Main_010
The setup as shown in attachment is as follows;
Pfsense, WanOs, Win7 (default ports)
Pfsense_010, WanOS_010, Win7_010 (Vlan10)
vSwitch2 is acting as a bridge between Pfsense & WanOs
On Win7, there is a website hosted and it can be accessed locally i.e. http://localhost.
If the website is accessed from Win7_010 (pfsense has nat rule for publishing http), site won't load and
internet & access to pfsense web gui stops for couple of minutes from both desktops.
Please suggest.